ADTRAN 600 SERIES Instruction Manual download pdf (Page 54)

Total Access 600R User Interface Guide (UIG)

PVC

The packets which transmit out this PVC from the Total Access 600R can be filtered in three ways:

XCEPTIONS

This is a list of up to 32 filter entries. The setup is exactly the same as the F

ILTER

XCEPTIONS

list.

Maintenance DLCI

The Total Access 600R can be configured from the WAN without having to preset a DLCI mapping or

IP address. This value is the DLCI number used to open an IP session by the Total Access 600R. Any IP

packet arriving from the PVC is assumed to be for the Total Access 600R’s IP stack. The destination

address in the packet is assigned as the PVC’s local IP address. The source address is used to add a host

route in the routing table. The default is 901, but any legal DLCI number can be used.

BECN Timeout (msec)

This value is expressed in milliseconds and represents the amount of time the Total Access 600R will

stop transmitting over a PVC which received a packet with the BECN bit set. The default is 1.5 seconds.

ROUTER>STATUS

Use the R

OUTER

TATUS

menu to view and set the parameters shown in Figure 10. The R

OUTER

TATUS

screens

give the user useful information for debugging the current routes in the 600R.

Figure 10. Router/Status Menu

ISABLE

)

Turns off packet output filtering. No outgoing packets to this

PVC are blocked.

LOCK

All outgoing packets to this PVC are blocked except as defined

in the F

ILTERS

XCEPTIONS

list.

ORWARD

All outgoing packets to this PVC are not blocked except as de-

fined in the F

ILTERS

XCEPTIONS

list.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 73 74

Comments to this Manuals

No comments

ADTRAN 600 SERIES Instruction Manual Page 54

Comments to this Manuals

Related products and manuals for Networking ADTRAN 600 SERIES