! RLH Industries, Inc. • Tel. 866-DO-FIBER • Fax 714 532-1885 • www.fiberopticlink.com! Page 12 Channel T-1 MuxFiber Link Card System2 Channels of
Local LoopbackThe local (LLOOP) loopback DIP switch is provided to allow for local loop back of each of the T-1 lines for troubleshooting purposes.The
Power IndicatorThe PWR (green) LED will be ON when acceptable power is detected at the card. Span power or a local power source can provide enough pow
NIU CompatibilityCheck for compatible NIU systems that supply Span Through-Power to the 2 Channel T-1 Mux Fiber Link cards. Contact RLH for T-1 compat
General SpecificationsTra nsmiss ion me thodAmplitude modulated light via two optical fibersAmplitude modulated light via two optical fibersTra nsmiss i
Dimensions1.24 in. (31mm)6.94 in. (176mm)3.93 in. (100mm)PWR2 12 12CH T1 MUXFRM ALARM (Y)FIBR FRM (G)BPVREM CH ALARMTXRXACTIVE (G)AIS (R)T112DC POWER2
WarrantyRLH is recognized throughout the U.S. and offers the only UNCONDITIONAL LIFETIME WARRANTY in the telecommunications industry. We are very prou
RLH Industries, Inc.6/$0/%*5*0/"--*'&5*.&8"33"/5:."%&*/64"RLH INDUSTRIES, INC. FIBER OPTIC LINK produ
General safety practicesThe equipment discussed in this document may require tools designed for the purpose being described. RLH recommends that servi
ApplicationThe 2 Channel T1 Fiber Link system combines up to two incoming DS1 data signals at 1.544Mbps, and optically transmits this signal over fibe
The CO sideThe 2 Channel T1 Fiber Link Card provides the interface between one or two Telco Central Office T-1 copper 4-wire lines over two strands of
InstallationPrior to installation:• Check for shipping damage• Check the contents to ensure correct model and fiber type• Have a clean, dry installatio
Refer to the power supply connection and use information for fuse or circuit breaker requirements. Use caution when handling copper wiring. Power conn
Note card orientation in housing during installationHandle card by edges. Install in slot 1 or next available card slot. Install card into housing bef
ConnectionsConnect Fiber Optic CableThe T1 cards are equipped with two optical connectors. Connect the fiber to the Transmit and Receive fiber connect
T-1 Surge ProtectionThermistors, and Sidactors limit transients appearing between the Tip and Ring of each pair. Transients appearing at the power ter
Comments to this Manuals