Adtran T1 CSU ACE User Manual download pdf (Page 28)

Chapter 2. Installation

28 T1 CSU ACE User Manual 61203022L1-1B

WALLMOUNTING THE UNIT

The T1 CSU ACE may be installed in a wallmount or tabletop

configuration. The following section provides step-by-step instructions

for wallmounting the unit

Instructions for Wallmounting

Step Action

1. Decide on a location for the T1 CSU ACE. Mount the unit

at or below eye-level so that the LEDs are viewable.

2. Prepare the mounting surface by attaching a board

(typically plywood, 3/ 4" to 1" thick) to a wall stud, using 3”

wood screws.

Important! Mounting to a stud ensures stability. Using

sheetrock anchors may not provide sufficient long-term

stability.

3. Install two #8 (1 1/ 2" or greater in length) wood screws

into the mounted board following these guidelines and

referring to Figure 7:

• Screws should be spaced horizontally, approximately

5” apart. Find exact positioning by using the location

of the two eyed insets on the bottom of the unit as a

guide.

• Screws should be horizontally level with each other.

• Leave approximately 1/4” of the screws protruding

from the board to allow the heads of the screws to

slide into place in the unit’s keyed insets.

4. Slide the keyed insets on the bottom of the T1 CSU ACE

chassis securely onto the screws.

5. Proceed to the steps given in Powering the Unit on page

30.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Adtran T1 CSU ACE User Manual Page 28