ADTRAN 6240 Installation Guide download pdf (Page 18)

Unit Installation NetVanta 6240 Series Hardware Installation Guide

4. UNIT INSTALLATION

The instructions and guidelines provided in this section cover hardware installation topics, such as mounting

options and supplying power to the unit. These instructions are presented as follows:

• Tools Required on page 18

• Mounting Options on page 19

• Supplying Power to the Unit on page 22

For information on configuration for a specific application, refer to the configuration guides provided on

ADTRAN’s Knowledge Base at http://kb.adtran.com

. For details on the command line interface (CLI), refer to

the AOS Command Reference Guide

(ADTRAN’s Knowledge Base article 2219).

Tools Required

The customer-provided tools required for the hardware installation of the NetVanta are:

• Ethernet cables

• Network cables (module dependent)

• Phillips-head screwdriver

• Drill and drill bit set (wallmount applications only)

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

• The NetVanta 6240 Series is intended to be installed, maintained, and serviced by

qualified service personnel only.

• Ethernet cables are intended for intrabuilding use only. They should not be run outside

the building.

To access the CLI of the NetVanta, you will also need a VT100 terminal or PC with

terminal emulation software and a console port cable. Instructions on how to access the

CLI are given in the quick start guide (shipped with your unit) or in the AOS Command

Reference Guide (ADTRAN’s Knowledge Base article 2219).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

No comments

ADTRAN 6240 Installation Guide Page 18