ADTRAN NetVanta 160 User Manual download pdf (Page 17)

NetVanta 160 Series Wireless Configuration Guide Configuring the AOS AP

After selecting the Add New AP button, the following configuration settings are available.

Link to the

MAC ACL.

Figure 12. Access Point Configuration Menu

The MAC address of the AP can be obtained by looking at the label on the bottom of the unit. The unit’s

MAC address will also show in the Dynamically Discovered Access Points menu when the AP is first

discovered.

The Ethernet speed, duplex, and 802.1q settings are configured from the Access Point Configuration

menu. A MAC address filter, as well as IP addresses and syslog forwarding settings, can also be applied to

allow only specific clients to communicate with the AP. The MAC access control list (ACL), accessible

from a hyperlink on the right of the menu, must be created before you can apply the MAC address filter to

the AP.

For more information regarding the configuration of MAC ACLs, refer to Appendix B.

Creating MAC ACLs Using the GUI and CLI on page 49.

Each AP ID is designated in the form dot11ap <ap>. The <ap> represents the interface

number to which the AP is assigned.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

No comments

ADTRAN NetVanta 160 User Manual Page 17