ADTRAN NetVanta 160 User Manual download pdf (Page 7)

NetVanta 160 Series Wireless Configuration Guide Configuring the AOS AP

Configuring the AOS AP

There are two ways to begin configuring an AOS AP: (1) the Web-based graphical user interface (GUI)

and (2) the command line interface (CLI). The remainder of this configuration guide pertains particularly

to the GUI; for descriptions of CLI functions, refer to the

AOS Command Reference Guide.

Accessing the GUI

You can access the GUI from any Web browser by following these steps:

1. Connect the AC to your PC using the switchports labeled 0/1 to 0/n or the ETH 0/1 or ETH 0/2 ports

on either the back or the front of the unit depending on the product. Also, connect the AOS AP to the

AC either by using the ETH 0/1 or ETH 0/2 ports on the back of the unit or by connecting the AP to a

switchport somewhere in the attached network. As long as the controller and AP are connected by the

same broadcast domain, control can be established.

2. Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address, you will

need to change the AC’s IP address using the CLI. (Refer to the quick start guide shipped with your

ADTRAN controlling unit for instructions).

3. Enter the AC’s IP address in your browser address line in the following form: http://<ip address>

, for

example:

http://60.26.109.200.

4. At the prompt, enter your user name and password (the default settings are admin and password).

5. The initial GUI menu appears.

1 2 3 4 5 6 7 8 9 10 11 12 ... 57 58

No comments

ADTRAN NetVanta 160 User Manual Page 7