ADTRAN TSU LT User Manual download pdf (Page 29)

TSU LT User Manual Chapter 3 Operation

Figure 3-3. TSU LT Main Menus

Status

Use the S

TATUS

menu to view the operational status of the TSU LT. (Also see Status Menu on page 35.)

This menu includes the following submenus:

Config (Configuration)

Use the C

ONFIGURATION

menu to set the TSU LT operational configuration. (Also see Config Menu on

page 39.) This menu includes the following submenus:

1) NI PERF REPORTS

1) STATUS 2) CURR ERR/ALM

3) ERR/ALM HIST

1) NETWORK (NI)

TSU LT Main Menus 2) CONFIG 2) UNIT

3) PORT 1) SOFTWARE REV

3) UTIL 2) REINIT UNIT

3) ADDRESS

1) NETWORK TESTS 4) SET PASSCODE

4) TEST 2) RUN SELFTEST 5) KEYPAD

3) PORT TESTS 6) FACT RESTORE

NI PERF RPTS

Use to view and reset the user set of data on the Network Interface Performance

Reports. These reports are in compliance with ANSI T1.403 and AT&T

document TR54016.

CURR ERR/ALM

Use to view current errors and alarms as reported by the TSU LT.

ERR/ALM HIST

Use to view and clear the history of errors and alarms.

NETWORK (NI)

Use to set all of the parameters associated with the network interface.

UNIT

Use to control the TSU LT control-port baud rate and to set up the dial-out

function.

PORT

Use to configure the parameters associated with the DTE (V.35) port.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

No comments

ADTRAN TSU LT User Manual Page 29