ADTRAN Vanta 1335 Installation Guide download pdf (Page 38)

Unit Installation NetVanta 1335 Series Hardware Installation Guide

Figure 15. Wallmount Installation

Supplying Power to the Unit

The NetVanta 1335 Series units come equipped with an either a 120 VDC 50/60 Hz or 240 VDC 50/60 Hz

power supply for connecting to a properly grounded power receptacle. (All appropriate power cords are

included in the shipment of the unit.) To power these units, connect the power cable to an appropriately

grounded power source.

Instructions for Wall Mounting the NetVanta

Step Action

1 Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with the

mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the

chassis (see Figure 15).

2 Decide on a location for the NetVanta. All NetVanta 1335 Series units are mounted with the

front panel facing down (see Figure 15). Keep in mind that the unit needs to be mounted at or

below eye level so that the LEDs are viewable.

3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)

to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.

Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide

sufficient long-term stability.

4 Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in

length) wood screws through the unit’s brackets and into the mounted board (see Figure 15).

5 Proceed to the steps given in Supplying Power to the Unit below.

SLOT 1 NIM/VIM

CONSOLE

100-250 VAC

50-60Hz

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

No comments

ADTRAN Vanta 1335 Installation Guide Page 38