ADTRAN Total Access 3000 Specifications download pdf (Page 15)

Front Panel Operation

61181310L2-5D 7

Front Panel Bantam Jacks

Monitoring of DSX signal characteristics can be performed through two sets of front panel

bantam jacks. Table 4 describes the functions of the jacks and test points.

Bantam EQ and MON test jacks provide two monitoring functions depending on the mode of

the module:

• Office Repeater (OR)

• Network Interface Unit (NIU)

NOTE

EQ Jacks do not function in NIU mode if the customer equipment

is connected to the DSX interface.

CAUTION

EQ testing is intrusive. Do not use EQ bantam jacks if there is

equipment attached to the DSX connection on the Total Access

3000 backplane.

Table 4. Bantam Jack Test Directions

Function Description

MON

(non-intrusive)

DSX MON Office Repeater Mode:

• TX to customer

• RX from customer

(intrusive)

DSX EQ T1-OR mode:

• TX to customer or network*

• RX from customer or network*

* Direction of the EQ Jacks depends upon the EQ Jack direction option on the Loopback and Test screen as well

as the network source provisioning option. Refer to “Loopback and Test” on page 21 for further information.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

ADTRAN Total Access 3000 Specifications Page 15